I'm a little sad that the quality of QuickSync is so poor at times...
I get lots of blocks and some gradient errors

according to this guide it SHOULD be possible to get better quality with QS:
http://www.extremetech.com/computing/12 ... nscoding/5
They talk about CABAC, that it should be enabled (dont know much about encoders and decoders) - and dont know if its possible to enable while capturing.
I hope that your are working on improvements were possible...
IF there are settings available for the QuickSync encoder, my wish would be that you would enable me to fiddle with them, using an ADVANCED tab in the program. Thereby i could experiment with the settings to get the optimal video quality.
some examples below:
NOTE: all these images are from the same video !
BAD Quality 1
full size image

BAD Quality 2
full size image

GOOD Quality 1
full size image

GOOD Quality 2
full size image
